In Switch Configuration, select or clear the interfaces you want to be part of the switch. To create/edit a switch configure the fields in the tabs: Note - Between the LAN ports of a switch, traffic is not monitored or inspected. In the table, these ports have the status Assigned to Internet.Ī LAN Switch is a group of LAN ports (for example, LAN2, LAN3, LAN5) that are grouped together and represented by the "pivot" port (the port with lowest index, LAN2 in this example). You can also use unassigned LAN ports to create an internet connection. Each network is configured separately under a specified transmitter. There are two radio transmitters: 2.4 GHz and 5 GHz. This can also be done through the Device > Wireless page. On wireless devices - Add new wireless networks ( Virtual Access Points). The LAN Bond can be an unassigned network. This improves performance and redundancy by increasing the network throughput and bandwidth. A single network device can have multiple connections to a network.Ĭreate and configure VPN tunnels (VTI) which can be used to create routing rules which determine which traffic is routed through the tunnel and therefore also encrypted (Route based VPN).Ĭreate a BOND ( Link Aggregation) between two or more interfaces. With an alias IP, you can associate more than one IP address to a network interface. Note - DMZ is not supported in 1530 / 1550 appliances.Ĭreate an alias IP. Traffic in a bridge is always monitored and inspected by the appliance.Ĭreate and configure tag based VLANs (802.1q) on any of the LAN interfaces or DMZ. Traffic is not monitored or inspected between the LAN ports of a switch.Ĭonfigure multiple bridges between interfaces. You can create tag-based VLANs under separate LAN ports and DMZ or under a LAN switch. The Network table shows all available network connections.Ĭonfigure multiple switches (port based VLANs) between the available local LAN interfaces and wireless networks. A switch is similar to a bridge but can perform data transmission between multiple port pairs at the same time. The Device > Local Network page lets you set and enable the local network connections, switches, bridge or wireless network (on wireless devices only).Ī bridge connects two or more local area networks (LANs).
0 kommentar(er)
